LIQUI MOLY MOLYGEN MOTOR PROTECT 500ml

Antifriction additive for long-term protection of the engine Molygen Motor Protect

The latest anti-friction and protective additive Molygen Motor Protect is based on organic compounds with tungsten, acting as an active element. Due to the high-temperature alloying of the friction surface with tungsten ions, the most durable heat-resistant layer is formed. As a result, engine friction is greatly reduced, and friction surfaces are protected from thermal overload.
Add for all the most modern cars that use low-viscosity and low-ash oils. The effect of a single application application is supported by more than 50,000 km.

Synthetic additive based on organic compounds of the latest development, keep tungsten. The additive works in accordance with quality control technologies - through high-temperature alloying of friction surfaces with tungsten ions (W) they create a durable heat-resistant layer that lasts more than 50,000 km. The new layer has a more even structure, due to which friction is significantly reduced, and the highest resistance to thermal overload and mechanical damage is achieved. Due to the unique properties of the latest methods of measuring wear, long service life, lower fuel consumption and improved environmental performance.

- Mixed with all commercially available engine oils.
- Maximum reduction of friction and wear
- Creates the strongest surface layer resistant to thermal and mechanical overloads
- Fully soluble in oil
- Reduces fuel consumption
- Substantially increases engine life
- Smoothes friction surfaces
- Improves smoothness of the motor
- Very resistant to high contact pressure
- does not increase the amount of phosphorus and sulfur in engine oil
- Tested on turbocharged engines with catalytic converters and diesel particulate filter (DPF)
- Prevents engine damage due to extreme conditions (oil leakage, very high loads, overheating)
- The effect persists over 50,000 km

In addition, Molygen Motor Protect uses advanced technological solutions that maximize the service life of the engine and protect it from thermal and mechanical overloads. Protection is long term.

It is recommended to add Molygen Motor Protect to engine oil every 50,000 km during a scheduled oil change. Packs of 500 ml is enough for 5 liters of oil. It is convenient to add an additive immediately after the shift or shortly after changing the engine oil. Add compatible with all mineral or synthetic motor oils.
Warning: do not use wet clutch on motorcycles!