ABRO Carb & Choke Cleaner 283g

Dissolves and removes carbon deposits, carbon deposits, oil and other contaminants from throttle valves, carburetor and other parts of the fuel system.
Suitable for carburetor and injection engines (EFI, MPI, GDI, FSI, etc.)
The carburetor and throttle cleaner allows you to reduce fuel consumption, improve engine start, and restore idle speed.
When using low-quality gasoline, it is recommended that you use a carburetor cleaner every 7,000-10,000 km.
In addition to the main purpose, it can be used to clean any oily contaminants, soot, and grease.

When using low-quality gasoline, it is recommended that you use a carburetor cleaner every 7,000-10,000 km. In addition to the main purpose, it can be used to clean any oily contaminants, soot, and grease.
Mode of application:

Remove the air filter and treat the outer surface of the carburetor.
To remove carbon deposits and other deposits from the throttle, spray a small amount of cleaner inside the carburetor with the engine idling.
Automatic choke: spray cleaner onto the choke while moving it by hand. If the shutter continues to jam, remove it. Start the engine and spray cleaner inside the carburetor.
PVC valve (crankcase ventilation valve): Disconnect the valve body and spray a small amount of cleaner onto the valve. Perform this procedure with a cold engine. Wait a few minutes. Then start the engine and spray the agent on the valve again. Wait 1 minute and turn off the engine.
Inlet temperature sensor: spray cleaner onto the valve with the ignition off, wait a few minutes. Move the valve back and forth until it moves freely.
Caution: Do not apply on painted surfaces. In case of contact, rinse immediately.