iMAGNET PSF Repair fluid for power steering

Solves problems:

● insufficient fluid pressure due to wear of the pump;
● hum and vibration in extreme steering positions;
● “tight” steering.

Safe for oil seals. It does not contain solid particles.

  Detected in UV rays.

iMAGNET PSF Repair fluid for power steering

Solves problems:

● insufficient fluid pressure due to wear of the pump;
● hum and vibration in extreme steering positions;
● “tight” steering.

Safe for oil seals. It does not contain solid particles.

 Detected in UV rays.

WITHOUT SOLID PARTICLES

Does not contain particles that can damage the seals GUR

SYNTHETIC BASIS

Compatible with all hydraulic oils

FULL PACKAGE OF ASHZOLES

Repair fluid is completely soluble in oil to achieve fluid homogeneity in power steering.

LIGHT IN THE UV

Rapid spot detection

In the event of increased noise in the operation of the hydraulic booster, vibration, tight steering, or detection of a hydraulic fluid leak, we recommend adding repair fluid for the iMagnet PSF power steering. It restores the antioxidant properties of the hydraulic fluid.

enhances corrosion protection in the assembly
improves the antifoaming properties of the working fluid
improves antiwear properties of hydraulic fluid
reduces hydraulic pump noise caused by increased wear on pump cavities
prevents impeller seizing due to antiwear additives
eliminates the cause of the “tight rudder”, restoring the working pressure of the pump and reducing fluid leakage in the spool cavity
does not adversely affect rail seals
iMagnet PSF should be poured into the expansion tank of the power steering system in the amount of 1-2 bottles (not more) per 1 liter of hydraulic fluid

Mode of application:

1. Warm up the engine to operating temperature

2. Install the wheel straight, then plug the vehicle

3. Fill the iMagnet PSF into the expansion tank of the power steering system. Before use, it is advisable to warm the bottle to + 20'C.

4. Start the engine and let it run for 5 minutes without changing the position of the steering wheel.


IT IS NOT RECOMMENDED TO FILL IN A LIQUID TYPE DEXTRON II WHEN USING THE CAR BELOW 0 ° C AND TYPE DEXTRON III WHEN OPERATING BELOW -10 ° C.

Dosage:

1-2 bottles per 1 liter of hydraulic fluid.

In the absence of effect, it is possible to use an additional bottle, but no more.

If necessary, a part of the working fluid in an amount equal to the volume of the iMagnet PSF additive to be added can be removed.