Strong cleaning agent for carburetor parts.
The fast-acting solvent formula combines high
the solubility of aromatic and polar solvents.
CARB & EGR CLEANER PRO is intended for
restoration of the carburetor without the need for disassembly and
cleaning the entire system.
2. Properties
Quickly dissolves mud deposits on the carburetor.
Removes carbon deposits, scale, tar, varnishes, rubber, paraffin and gasoline.
Provides quick start of the engine and its smooth idling
to go.
Provides the most economical fuel consumption.
Does no harm to the catalytic converter and oxygen sensors.
Reduces hydrocarbon production and controls the exhaust gas composition of cars without
catalytic converters.
Saves maintenance time.
Eliminates the need to use metal wire brushes, thereby allowing
Avoid the risk of damage to soft metal alloys.
Does not contain chlorinated solvents.
Aerosol cans are equipped with a valve (works in any position of the can) and
additional tube for ease of use and accurate application.
Aerosols are pressurized with a CO2 propellant that allows full
balloon volume by 97%.
3. Application
Carburetor Parts
Automatic carburetor flaps
Crankcase ventilation systems and valves
Elements of the crankcase breather
Exhaust Valves
Heating control valves
Fuel systems
4. Instruction
4.1 Carburetor Cleaning
Shut off the engine and allow it to cool. Remove the air filter.
Spray a small amount of the product inside the carburetor so that all are moistened.
visible details.
Spray the product onto the exterior surfaces so that they become clean, and then leave
dry.

Start the engine. While the engine is running at medium revs, inject
directly into the air intake. Step on the gas pedal.
Shut off the engine. Lubricate exterior surfaces and components with CRC 5-56.
Replace the air filter and adjust the component ratio if necessary
combustible mixture.
4.2 Cleaning other products
Provide access to the surface to be cleaned by removing the cover, disconnecting the hose, etc.
• If possible, spray the product from all directions, allowing it to penetrate into all places. Cleaning
heated control valves, carburetor automatic shutters, exhaust valves
exhaust gases should be carried out with the ignition switched off and the engine cool. During
Cleaning the crankcase ventilation system The engine must run at high speeds.
If necessary, grease the surface with CRC 5-56 and replace the covers, hoses and
etc.