$33.00
On Hold
CRC Fast Motor Flush 5-Minute Engine 887g
Only 1 available
Details
Shipping: US-Mainland: free (more destinations)
Condition: Brand new
Returns: 7 days, buyer pays return shipping (more)
In modern conditions of increasing the duration of oil change intervals, there is an increase in the accumulation of sediments, sludge, resins and varnish carbon deposits inside the engine. It is imperative that the engine is thoroughly flushed (cleaned) before refueling with new engine oil.
CRC FAST MOTOR FLUSHTM - Rapid Engine Flush:
- Releases stuck valves, pushers and piston rings.
-Provides easy oil access to all engine parts.
- It is recommended to use at least 2 times a year or every 5000-6000 miles (8050-9654 km) during oil change.
-It is recommended to use until a thorough inspection (bulkhead) of the engine.
Safe for oil seals, gaskets and valve stem seals. Effective in relation to all types of motor oils.
For use in gasoline and diesel engines.
APPLICATION: Follow the instructions in order.
1. Use CRC Fast Motor Flush only until oil changes.
2. Turn off the engine and check the oil level to make sure that the oil level indication does not exceed the maximum level mark. Flush with an old oil filter.
3. Add one can of CRC Fast Motor Flush to the oil in the crankcase. (For a crankcase with a volume of more than 5 quarts (4.76 L), it is recommended to use approximately 20% CRC Fast Motor Flush for each additional 0.946 L of oil). Start the engine and let it idle for 5 minutes. Do not drive or accelerate the engine until the oil is completely replaced.
Note: make sure the engine is idling in an open area or in a room with very good ventilation.
4. Turn off the engine and drain the oil immediately. Replace the drain plug. Remove the oil filter and install a new filter and drain plug,
5. Fill the engine with new engine oil. Start the engine and let it idle for several minutes to make sure that the new oil is clearly circulated to all important details.
6. Do not spray on live equipment and / or machinery.
CRC FAST MOTOR FLUSHTM - Rapid Engine Flush:
- Releases stuck valves, pushers and piston rings.
-Provides easy oil access to all engine parts.
- It is recommended to use at least 2 times a year or every 5000-6000 miles (8050-9654 km) during oil change.
-It is recommended to use until a thorough inspection (bulkhead) of the engine.
Safe for oil seals, gaskets and valve stem seals. Effective in relation to all types of motor oils.
For use in gasoline and diesel engines.
APPLICATION: Follow the instructions in order.
1. Use CRC Fast Motor Flush only until oil changes.
2. Turn off the engine and check the oil level to make sure that the oil level indication does not exceed the maximum level mark. Flush with an old oil filter.
3. Add one can of CRC Fast Motor Flush to the oil in the crankcase. (For a crankcase with a volume of more than 5 quarts (4.76 L), it is recommended to use approximately 20% CRC Fast Motor Flush for each additional 0.946 L of oil). Start the engine and let it idle for 5 minutes. Do not drive or accelerate the engine until the oil is completely replaced.
Note: make sure the engine is idling in an open area or in a room with very good ventilation.
4. Turn off the engine and drain the oil immediately. Replace the drain plug. Remove the oil filter and install a new filter and drain plug,
5. Fill the engine with new engine oil. Start the engine and let it idle for several minutes to make sure that the new oil is clearly circulated to all important details.
6. Do not spray on live equipment and / or machinery.
RU, RUSSIAN FEDERATION