Glue-cold welding for metal


Glue for metal with a special filler is intended for fast and reliable bonding, repair, sealing of joints, as well as for the restoration of lost fragments of products from dissimilar metals: steel and its alloys, including stainless, aluminum, brass.

Eliminates the occurrence of electrochemical corrosion at the bonding of metals. The operating temperature of the repaired products is from -60 ° C to +150 ° C. It provides reliable repair on wet and oily surfaces, at low (up to -10 ° С) temperatures (provided that the mixture is mixed in a warm room).

Mode of application:

The glued surfaces clean of dirt and rust, clean with sandpaper, degrease and dry. Cut the part of the rod necessary for volume and carefully mix both components with your fingers (you can wet) to obtain a uniform color of the mass. Apply the resulting mixture to the surface to be repaired and, if possible, press and fix for 15 minutes. When used on wet or oily surfaces, the mixture must be smoothed back and forth until it sticks to the surface (the bond strength is reduced by 20-25%). If it is necessary to repair at low temperatures, it is recommended to roll the ball from a thoroughly mixed composition and hold it in your hands until it warms up to 40-50 ° C (but not more than 4 minutes from the beginning of stirring), then apply to the area to be repaired. To smooth the surface and give it the necessary shape, use flat objects moistened with water.

ATTENTION! The pot life of the mixture is 5-7 minutes. at 20 ° C. Under conditions that ensure the removal of heat (thin layer, low temperature, etc.), the pot life increases, when heated, it decreases. The composition "sets" in 15 minutes at 20 ° C. At this time, mutual fixation of the connected parts is necessary. After 1-1.5 hours, the connection can be machined and loaded.