Permatex Anaerobic pad former for
mechanical aluminum surfaces is
one-component, medium-strength, thixotropic,
anaerobic sealant that cures for
short time. Gasket former
vulcanized in the absence of air access
between two tightly pressed against each other
metal surfaces. Shaper
gaskets provide impact-resistant, elastic,
resistant to adverse effects
solvents and temperature sealant capable of
take the shape of a part that changes due to
exposure to vibration, pressure or fluctuations
temperatures. Has a manufacturer's certificate
complex equipment.
PRODUCT ADVANTAGES
• Does not require pre-mixing
components
• Does not vulcanize outside the joint
• Does not corrode aluminum or cast iron
surfaces
APPLIES
• In aluminum mechanical components
• In pumps
• In thermostats
• In casings
• In the bridge guard
• At the checkpoint
• In a split crankcase

APPLICATION INSTRUCTIONS
1. Clean the treated surfaces from
lubricants, oils and dirt. For removing
oils, it is recommended to use Cleaner
Permatex Brake Parts
Brake and Parts Cleaner.
To remove old gaskets, it is recommended
use Permatex Gasket Remover
Gasket
Remover.
2. Apply the gasket former by hand
continuous layer on one side flange, making
sure a continuous is applied.
3. Mount.
4. Tighten the fasteners in the usual manner.
5. Withstand parts to cure the former
gaskets within 1 hour before the first use.

Completion of the repair
1. Remove excess gasket former dry
pure matter.
2.Clean your hands with a Scented Hand Cleaner
orange Permatex
Fast Orange®
or using
water and soap.
Dismantling
1. When disassembling small parts,
apply local heating of the surface from
204.4 C to 232.2 C (400F to 450F).
2. Sharp, light tapping and
detach the parts with loosening movements.
Repeat the procedure if necessary
heating / loosening.
3. When dismantling large parts
a small hammer must be used and
tool for loosening / breaking parts
with which to start loosening and
chipping off parts fastened together.
4. After dismantling, it is necessary to withstand the time until
finding the surfaces of room parts
temperature.
5. To remove anaerobic materials
it is recommended to use a gasket remover
Permatex Gasket Remover.
Color Red