PERMATEX High Strength Threadlocker Red Gel 10g

PERMATEX High Strength Threadlocker RED Gel is a high
strength anaerobic threadlocking gel conveniently packaged
in a new Gel Twist or Gel Squeeze applicator. The
product, like its liquid counterpart, is a single component,
anaerobic gel that cures when confined in the absence of air
between close fitting metal surfaces, ideal for all 3/8 inch to 1
inch (10mm to 25mm) and greater diameter threaded
assemblies. Excellent chemical resistance and temperature
resistance range of -65°F to +300°F (-54°C to +149°C). The
assembly may require the use of heat to remove bolts. NSF
Nonfood Components Program Listed (P1) (135870).
PRODUCT BENEFITS
Improved Reliability
• Eliminates vibration issues
• Seals against leakage
• Prevents rusting of threads
• Designed for use on vertical or hard-to-reach applications
• Cures without cracking or shrinking
• Adjusts or disassembles with hand tools
Easy Application
• No mess Gel Twist or Gel Squeeze applicator
• Gel-type product does not drip when applied
• Single component
• No curing outside of joint
• Thixotropic: resists dripping from threads during assembly
• No torque compensation required during assembly
TYPICAL APPLICATIONS
Prevents loosening and leakage of threaded fasteners.
Particularly suitable for applications such as:
• Transmission shaft bolts
• Cylinder block
• Rocker arm studs
• Ring gear bolts
• Fan hub bolts
• Shock absorber bolts
• Frame brackets
• Frame bolts
• Hydraulic press studs
• Suspension fasteners
• Large studs
• Heavy equipment bolts
• Gear bolts
• Railroad assemblies
• Construction equipment
For assembly
1. Clean all threads (bolt and hole) with a cleaning solvent
such as Permatex Brake and Parts Cleaner and allow to
dry.
2. Remove the translucent protective cap by pulling off at an
angle.
3. For Gel Twist turn the dial on the bottom of the container
until 1/8” to 1/4" (3mm to 6mm ) of material protrudes from
the top of the application tip. Note: First time use may
require 4 to 5 full turns of the dial before material appears in
the tip.
For Gel Squeeze, remove cap and squeeze 1/8” to 1/4"
(3mm to 6mm) of material beyond tip.
4. Apply threadlocker to the engagement area of the male
fitting (usually the leading 5 to 6 threads).
5. Assemble parts and tighten to recommended torque.
6. If unused gel contacts metal threads, do not retract
threadlocker back into the tube. Wipe off with a clean towel.
7. Replace protective cap.
For Cleanup
1. Residual liquid films and/or fillets outside the joint are
readily soluble in Permatex Brake and Parts Cleaner.
2. Cured product can be removed with a combination of
soaking in Permatex Gasket Remover and mechanical
abrasion such as a wire brush.
For Disassembly
1. Apply localized heat to nut or bolt to approximately 500°F
(260°C). Disassemble while hot.
For Reassembly
1. Remove loose product from nut and bolt following cleanup
procedure above.
2. Apply Surface Prep activator to all threads, regardless of
metal type and allow to dry.
3. Apply threadlocker gel as above.
4. Assemble and tighten as usual.