THE PARCEL IS SHIPPING BY SEA WITH A LONG DELIVERY TIME WITH TRACKING.

Cupper SAFELine 5W30 synthetic motor oil with a reduced ester content (up to 15%) is used for engines with high mileage, as well as old cars, since rubber parts of cars of this class have low resistance to synthetic oils. Cupper SAFELine 5W30 is designed for high-speed, high-load gasoline and diesel turbocharged engines, API SN / CJ-4 EC. It has a low percentage of volatility and, due to its low flow rate, does not have the effect of leakage through microcracks in aged gaskets.
The main advantage of Cupper SAFELine 5W30 synthetic motor oil is its good protection against engine oxidation and aging. Using engine oil will help you clean your engine of operational contamination. Recommended replacement frequency: 8000 km in urban cycle, up to 10000 km in mixed mode.

Cupper SAFELine 5W30 engine oil:

Provides improved resistance to oxidation and aging, especially under severe operating conditions.
Possesses exceptional detergent and dispersant properties.
Stable at high temperature loads
Can be used in climatic conditions from -35oС to + 50o
Improves the environmental performance of the engine.
Has good antifoam properties.
Reduces waste oil consumption.
Sulphated ash content - no more than 0.03%
SafeLine 5W30 oils meet the requirements of:
ACEA: C4, A3 / B4; API: SN / CJ-4EC; BMW: LONGLIFE-04; GM: dexos 2; MB: 229.51, 229.5; VW: 502 00, 505 00, 505 01; RENAULT: RN 0720.
Main characteristics
Volume, l
4
Marking
5W30
Flash point ° С
235
Viscosity index VI
170
Sulphated ash content%
0.04
CCS mPa * s
4700
Viscosity
10.8
Depth mm
155
Height, mm
250
Width, mm
155
Weight, kg
4
Vitaly Monakhov 08/03/2019 23:03:14
Thanks to Sergey Stepanovich for the recommendation !!! kia ceed 231 thousand kilometers and this is what I will write ..
The life of my car is divided into Up to Butter Cupper and with it.
The oil change period was always 8 thousand, as it turned out, this does not guarantee the cleanliness of the engine, because with oils, etc., there is a problem in Russia.
After 2 thousand km on the SAFEline, it felt like piston rings on one cylinder were released, after another 4 thousand on all four.
The rise uphill is especially felt - it became easier, without strain.
The speeds are switched at 2 thousand revolutions and not at 2500 as before
I didn't get to 8 thousand, changed after 7 thousand and did the right thing! I have not seen such black oil even when I used simple oils .. horror!
I filled in a clean SAFEline immediately it became easier for the motor .. but in my heart)
P.S for the first time use, you should not wait 8-10 thousand before changing the oil. because everything that it laundered can walk through the system (when the filter gets clogged, the recirculation mode turns on, as I was told, the oil bypasses the filter)

Andrey 06/02/2019 22:32:00
The story is as follows. Pickup truck Mazda BT-50. With a mileage of 435,000 km, I poured a detergent additive into engine oil. For 437 thous. km changed the oil and added the Cupper additive. I did not notice anything special. Well, the engine began to work quieter, well, the consumption is a little lower. At 447 thousand km, I completely changed the oil to Cupper. And here I felt the results, almost immediately: if at first the oil consumption increased, then by the end of 10,000 mileage, there is no waste, the engine runs quietly and evenly, if before it could drive 650-660 km on a full tank until the light came on, now I easily drive 700 -750 (in both cases, fuel consumption on the highway with a load of 50%, i.e. 500-600 kg). At first, the smell of oil was felt in the exhaust, now it's completely gone. At 445 thousand km, I changed the oil in the entire transmission to Cupper. I will describe the result after the replacement and in the comments to the transmission oil

Anton Gorbunov 04/19/2019 07:14:00
Great product. With him, old engines take on their former youth or a second wind, whoever you like. The effect is noticeable after 500-1000 km, and after 2000 the car will not be recognized. I have an oil consumption of 0.5-1l per 8000 km. I will try 5w40.

Konstantin Glushkov 02/18/2019 00:10:00
Good day! I drove 30,000 km on this oil (3 oil changes), so I'm ready to leave a full review. Car VW 1.6 BSE, mileage at the first change to Cupper oil over 400 thousand km. Before that I used Castrol EDGE 5W-30 LL oils, the last 200 thousand MOTUL 5W-30 504-507. Oil consumption is approximately 1 liter with a 10,000 km change. The reason for changing the oil to Cupper: 1) Reviews of the Cupper oil 2) Expert recommendations 3) Counterfeit branded oils on the market (the quality of the poured oil did not suit). To begin with, I used the Cupper flushing and after 1500 km I changed the oil to Cupper. The first changes were 300-350 km after the use of flushing. The engine began to run smoother, much quieter, vibration was gone when the engine was idling (VW 1.6 BSE owners will understand). The first oil change did not show much, oil consumption remained the same 1 liter for replacement, fuel consumption also did not change, the dynamics of the car slightly increased. Since the second oil change, fuel consumption has decreased by exactly 20% and over the next 10,000 km did not add a single drop of oil to the engine. At the same time, the dynamics of the car has increased significantly, the engine picks up speed very easily. At the next replacement, these indicators are preserved. I am quite satisfied with the result of the oil change, I definitely recommend Cupper products. I will definitely change the oil in the gearbox to Cupper.