TOTEK ASTRA ROBOT T-1000A Automatic transmission additive 100ml

The composite two-phase product "TOTEK Astra Robot T-1000A" was specially developed for automatic transmissions. The lubricant requirement for automatic transmissions is largely conflicting. The use of a separate type of oil for each gearbox system would significantly complicate the design of the gearbox and greatly reduce its reliability. Therefore, the developers of the automatic transmission took the path of creating an oil that could satisfy all the requirements in terms of its properties. The main thing is the speed of the gearbox - the oil must be liquid, but then the lubricating properties of the oil fall, and it must provide low friction losses in the gearbox. This property, as a rule, is sacrificed from which the mechanical losses in the automatic transmission are incomparably higher than in the manual transmission. "TOTEK Astra Robot T-1000A" allows you to largely eliminate these contradictions, and to enhance, first of all, the lubricating properties, as well as to increase the speed of the box by eliminating the reasons leading to a decrease in this speed by removing the dirt and varnish deposits accumulating on the parts of the automatic transmission and significantly affecting fuel consumption. "TOTEK Astra Robot T-1000A" does not change the duration and timing of oil change, the entire service life of the oil is used (according to the maintenance regulations). When changing oil, the product is re-introduced into fresh oil and so on every oil change.
Method of application The product is introduced in a volume of 20 ml. product per 1 liter of oil. It is best to inject the product into the oil heated to operating temperature (60-90C), for which you need to drive 40-60 km through the oil filler hole in the automatic transmission. If you have an oil control dipstick, you can enter the composition through the dipstick well using a funnel. After the introduction, it is necessary to let the mechanism work for 10 minutes on the road without accelerating loads, or better on a lift with the wheels hanging. Then the box is ready to go.