Auto energetic for all types of internal combustion engines (Doy-pack 100 ml)
The metal-coating additive component is intended for use in engine oils of any type.

Significantly improves the detergent properties of motor oils. Compatible with all types of motor oils, does not change their viscosity and other physicochemical properties;
protects metal friction surfaces with a copper film, partially restoring worn-out working surfaces of parts in friction pairs;
helps to improve the temperature regime, dynamic, economic and environmental characteristics of the engine;
increases the service life of the internal combustion engine;
does not affect the engine seals.


However, not only the cost has decreased! Please note that now auto power engineering, designed for use in units and assemblies with a small amount of oil, are produced in containers of smaller capacity. So, for example, an additive intended for manual transmissions, final drives and differentials or, an energy drink for power steering, is poured into 50 ml bags. and are designed to handle a unit with a volume of 2 liters.

Attention! Before use, energy drinks must be warmed to room temperature and shaken!
The contents of the package are designed to handle an engine with an oil system of 3 - 5 liters.


Mode of application:
pour the contents of the package into the oil system of the engine warmed up to operating temperature
let the engine run for 5 - 10 minutes at idle speed
continue to operate the vehicle in normal mode
designed for the entire life of the engine oil
Important: when switching to CUPPER, it is imperative
use the "CUPPER Flush Additive" as a preparatory step.
Pour it into old oil for 1000-1500 km. before the shift.

When the vehicle has traveled less than 20,000 km. - no flushing step is required for the units!